January 18, 2020

Gary sent in some photos of his recently completed cyclone dust collector based off of my design.  He had a few comments you can read below.

"Justin, thank you again for the fabulous project and video. I have struggled with dust collection in my small basement shop...

December 21, 2019

Several years ago I built a fantastic dust hood for my miter saw (see build here).  I did not make a video of this build nor did I make a 3D CAD model or plans for this hood.  However, it has been such a valuable tool in my workshop, and I have gotten lots of requests...

August 28, 2019

I recently completed a great accessory to my table saw - retractable casters.  Previously, I just had casters only.  While they are great for moving the saw around, they don't work great at keeping the saw still when trying to make cuts.  Nothing beats a solid table sa...

March 16, 2019

Daniel sent in some photos of his overhead table saw dust collector he built from my plans.

"The design is very well done. My arm is pretty long so it sags a little bit not to bad. I had a lot of trouble getting the acrylic cut. It kept cracking on me. I went through lo...

February 26, 2019

Bob from Bob Lee's Woodshop shared some photos of his camera rig he made based on my design.  He uses it to record videos for his youtube channel.  

Bob wrote on his Instagram page:

"Had a problem I wanted to use the front facing camera on my phone the solution...

February 21, 2019

Bob sent in some photos of his overhead table saw dust collector based on my design.

"I built a modified version of your over arm dust collector using a double articulated arm attached to the ceiling over my table saw. I have a Delta Unisaw with a large table and the di...

February 15, 2019

Dave from North Carolina sent in some photos of his overhead table saw dust collector and his plans to update his design to one similar to mine.

"Justin, Several years ago, I made an overhead dust collection system for my table saw. In concept it’s similar to yours. I h...

December 21, 2018

In this video I show how I re-purposed some patio door panels and turned them into sliding barn doors for my garage workshop.  There were a couple of requirements I considered which led me to this design.  First, I wanted a large clear opening, so I could easily roll o...

November 10, 2018

Chuck sent in some photos of his recently completed overhead table saw dust collector based off of my design.  He had a few comments you can read below.

"Justin, I completed my tablesaw dust collection on your design. I made the extra piece for cutting thin strips but h...

November 10, 2018

Update time!

I've been making good (but slow) progress on my new shop build.  In this video I show you the updates I've made so far and talk about the plans for the new wall.  

Completed so far:

  • Refinished two walls

  • Added ceiling

  • Updated outlets &...

Please reload

Justin Depew ©2020