top of page

VIEWER SPECIAL: Daniel's Overhead Dust Collector

Daniel sent in some photos of his overhead table saw dust collector he built from my plans.


"The design is very well done. My arm is pretty long so it sags a little bit not to bad. I had a lot of trouble getting the acrylic cut. It kept cracking on me. I went through lot of tries and it still cracked. But it’s good enough until I can possibly get some thicker acrylic. Also built your crosscut sled/miter saw hold down. That’s awesome!!"


Recent Posts

See All

VIEWER SPECIAL: Mike's Overhead Dust Collector

Mike sent in some photos of his overhead table saw dust collector he built from my plans. "The overarm build is finished in Ridged Orange. I have to say the suction power is a bit weak, so I purchased

VIEWER SPECIAL: Dave's Cyclone Dust Collector

Dave sent in a photo of his recently completed cyclone dust collector based off of my design. He had a few comments you can read below. "I just built a vacuum based on your video. I integrated the fi

VIEWER SPECIAL: Ron's Overhead Dust Collector

Ron sent in some photos of his overhead table saw dust collector he built from my plans. "Justin, This has been a great weekend project. Your directions were excellent. I only had to modify the length

Comments


Commenting has been turned off.
Post: Blog2_Post
bottom of page