VIEWER SPECIAL: Ron's Overhead Dust Collector

Ron sent in some photos of his overhead table saw dust collector he built from my plans.


"Justin, This has been a great weekend project. Your directions were excellent. I only had to modify the length of the arm (54”) to fit my table saw. It works like a charm."

I told Ron this was the longest arm I've seen anyone make to date. I asked him if he had any problems with this. He responded:


"When I raise the vacuum head the arm will drop about 3/4”. I adjust for that and everything works great. My only issue was when I would swing the arm away from the table. I fixed this by reinforcing the brace to the table. It’s not an issue any longer. Thank you again for your design. I love it. "


Recent Posts

See All

Mike sent in some photos of his overhead table saw dust collector he built from my plans. "The overarm build is finished in Ridged Orange. I have to say the suction power is a bit weak, so I purchased

Dave sent in a photo of his recently completed cyclone dust collector based off of my design. He had a few comments you can read below. "I just built a vacuum based on your video. I integrated the fi

Mark sent in some photos of his overhead table saw dust collector he built from my plans. "Hi Justin, I just thought I would follow up with you regarding the Over arm dust collection. I used your plan