top of page

VIEWER SPECIAL: Nathan's Dust Hood

Updated: Mar 30, 2021

Nathan sent in some photos of his completed miter saw dust hood he built using my plans. Nathan was able to accommodate his sliding Makita miter saw by adjusting the length of the dust hood as well as the hinged panels.


Great build Nathan!










Recent Posts

See All

VIEWER SPECIAL: Mike's Overhead Dust Collector

Mike sent in some photos of his overhead table saw dust collector he built from my plans. "The overarm build is finished in Ridged Orange. I have to say the suction power is a bit weak, so I purchased

VIEWER SPECIAL: Dave's Cyclone Dust Collector

Dave sent in a photo of his recently completed cyclone dust collector based off of my design. He had a few comments you can read below. "I just built a vacuum based on your video. I integrated the fi

VIEWER SPECIAL: Ron's Overhead Dust Collector

Ron sent in some photos of his overhead table saw dust collector he built from my plans. "Justin, This has been a great weekend project. Your directions were excellent. I only had to modify the length

Comentários


Os comentários foram desativados.
Post: Blog2_Post
bottom of page